Jumpers & Indicators

9min

JumpersJP9, JP10, JP11
﻿
﻿
With these jumpers, several settings can be forced
JP9: Reserved
JP10: Start with default IP address 172.22.2.100
JP11: Skip the bootloader
Indicators
﻿
The board uses several LEDs indicating activity.
Power
﻿
LED1 indicates that the external power is connected, this means that 24V and 5V are available.
﻿

 PWR This LED indicates that the power for the processor is available (3.3V).
Network
﻿
Yellow = Network activity (ACT)
Green = Network connection (LNK)
Status
﻿
Indicator
Color
Meaning
LED6
Red
SYSREADY indicates when CNC system is ready for operation. Can be used in cooperation with safety relay.
LED5
Red
WATCHDOG charge pump, indicates operation of the watchdog circuitry
LED4
Green
Controller ‘heartbeat’ indicating the board is active
LED3
Green
Indicates ‘Machine On’ 
LED2
Green
Flashing when application is starting up. 
After startup, will be switch ON if E-STOP occurred.
Please note, when in bootloader mode LED2 and LED3 will toggle to indicate this.
﻿

CNC760 - 6-Axis CNC Controller (400kHz)

Connectors

Docs powered by archbee

TABLE OF CONTENTS

Indicator	Color	Meaning
LED6	Red	SYSREADY indicates when CNC system is ready for operation. Can be used in cooperation with safety relay.
LED5	Red	WATCHDOG charge pump, indicates operation of the watchdog circuitry
LED4	Green	Controller ‘heartbeat’ indicating the board is active
LED3	Green	Indicates ‘Machine On’
LED2	Green	Flashing when application is starting up. After startup, will be switch ON if E-STOP occurred.