website logo
Home pageWeb storeDistributors
Software
Hardware
Settings
Troubleshooting
Navigate through spaces
⌘K
Hardware manuals
Controller Comparison
Controllers
CNC310
CPU5A4(E)
CNC530
iCNC600
CNC720
CNC760
Firmware upgrade
Firmware changelog
Getting started with your new controller
Accessories
SensorHUB
UIO-10
Wireless Pendant
Wired Pendant
Electronics Basics
Open Collector
Docs powered by
Archbee
Controllers
...
CNC310
Accessories

CNC310 Breakout Board

10min

If you prefer to use separate wires to hook up your CNC310, this breakout board will help you. Simply stack the CNC310 on top of this board and start wiring your controller.

Purchase

Document image


Contents

Each breakout board kit contains the following:

  • 1x Breakout board CNC310
  • 1x Connection cable CNC310
  • 8x 12mm spacers
  • 16x M3 bolt 6mm

Overview

Document image


Installation

The kit contains all the mounting material to mount a CNC310 controller and the breakout board.

1 Mounting PCB spacers on the breakout board

Document image


2 Attaching the cable to the CNC310

Next, the cable needs to be mounted, make sure the orientation is correct.

Document image


3 Connecting the CNC310 to the breakout board

Connect the CNC310 by inserting the cable into the box header on the breakout board.

Document image


4 Mounting the CNC310

Use 4 M3 screws to mount the CNC310 on the spacers.



Document image


Setup

This board can either be externally powered with 5V. By default, the 'EXT. POWER' jumper is not set. If you want to power it externally with 5V the jumper must be set to 5V.

EXT. POWER Jumper
EXT. POWER Jumper


If external power is applied, the jumper USBPWR on the CNC310 must be removed to avoid the PC's USB port being powered externally.

USBPWR Jumper
USBPWR Jumper




PREVIOUS
CNC310 Manual
NEXT
CPU5A4(E) Manual
Docs powered by
Archbee
TABLE OF CONTENTS
Contents
Overview
Installation
1 Mounting PCB spacers on the breakout board
2 Attaching the cable to the CNC310
3 Connecting the CNC310 to the breakout board
4 Mounting the CNC310
Setup
Docs powered by
Archbee