Hardware

💾Software
Hardware
Navigate through spaces
💾Software
Hardware
⌘K
CPU5A3/CPU5A4/CPU5A4E
Wireless Pendant
UIO-10
Docs powered by archbee 
4min

Firmware update

If a new firmware version becomes available it's possible to download it from the website. Besides the firmware, you also need the bootloader application. Both can be found on our website:

Download firmware and bootloader
Download firmware and bootloader

If you have downloaded both you can start the bootloader application.

Bootloader application
Bootloader application

The next steps are:

  1. Load the new firmware file (.CRY) by clicking on 'File'
  2. Connect to the UIO-10

Please note, that it is only possible to connect to the UIO-10 if it is in bootloader mode. This is indicated by two LEDs toggling. If the bootloader does not become active it's very likely that jumper #1 of JP1 is still mounted, please remove it, reset the board by removing the USB cable and start again.



Bootloader is connected, and FW is loaded
Bootloader is connected, and FW is loaded

The final is pressing the 'Program' button and the firmware is uploaded to the UIO-10.

Bootloading programming is finised
Bootloading programming is finised

The UIO-10 can now either restarted by unplugging the USB cable or issue a reset command by clicking on the 'Reset' button.





Updated 03 Aug 2022
Did this page help you?
Yes
No
Docs powered by archbeeÂ