Operation

Put 2 AA batteries in the Pendant. When the pendant is not used it recommended to switch it off, so the batteries are saved. 2Connect USB RECEIVER to USB port of PC. The USB receiver must have free line of sight to the pendant. This means, it will not work well if the USB receiver is built into a metal cabinet and the pendant is outside.

In Setup 2/2, you can find the button for setting up the pendant.



After clicking, you will see an overview of the supported pendant models. Select the correct model. It is likely that you need to select "Model 3".



Once the use of the wireless pendant has been enabled, (re)start the software. An additional, program that communicates with the pendant is also started, it looks like below and shows infoormation from the pendant:



It shows “Pendant found” if everything is OK. You can leave this running on the background, it will perform the Pendant functionality for Eding CNC.

The Pendant itself has a timeout; this is to preserve the batteries. It is important to know that after a few seconds of not pressing a button or not rotating the MPG, that the Pendant goes to a sleep situation where there is no longer communication with the PC. In sleep situation the positions on the display no longer match the actual machine position and the software goes automatically out of hand wheel operation. When a button is pressed or the MPG is rotated, it goes back to normal operation and the positions are updated.