First time use

when the software is started for the first time, an extra number of screens are shown the first dialog that will appear is the primary setup dialog this dialog serves two purposes indicate whether the machine is supposed to work in mms or inches indicate whether you want to import a previous configuration or continue with a 'clean' configuration in this case, we will select use mm s and 'proceed with demonstration configuration, i am evaluating the software or i need to configure the software myself ' and we continue by clicking on 'continue' in the following paragraphs, we will explain more if you want to import configurations tip if you want to re initialize the software as if there were no existing configuration all you need to do is delete all files from the 'config' folder except macro cnc when the software starts, it will cause this initial setup dialog to re appear import configuration from v5 installation ff import configuration from v4 installation fff release note & terms and conditions for end users when the software is first started, the 'general terms and conditions for end users' is presented at the bottom, you can click on agree, which will only appear the first time optionally, there will be a pop up asking if you would like to open the release notes this release note can also be found on this webpage