Home page
Web store
Distributors
Software
🏭
Hardware
Settings
Troubleshooting
Navigate through spaces
⌘
K
EdingCNC Documentation Pages
Getting started
PC Requirements
Software installation
Network setup
Software Manual
Introduction
First time use
Tab overview
Coordinates tab
Service tab
Setup tab
Keyboard shortcuts
Software license
How to...
Configuration Manual
Introduction
How to use
Milling un-even surfaces / Z-heigh compensation
Mapping X/Y G-code to cylinder on A-Axis
Linear pitch compensation
Configuring an automatic oil pump
G-code
Language standard
Supported G-code
Supported M-codes
Other input codes
Macro programming
Special commands
Special features
EdingCNC post-processor
Release notes
Docs powered by
Archbee
G-code
Supported G-code
G4 (Dwell)
1min
for a dwell, program g4 p this will keep the axes unmoving for the period of time in seconds specified by the p number it is an error if the p number is negative
PREVIOUS
G2, G3 (Arc at Linear Feed)
NEXT
G10 (Set Coordinate System Data)
Docs powered by
Archbee
Docs powered by
Archbee