website logo
Home pageWeb storeDistributors
Software
Hardware
Settings
Troubleshooting
Navigate through spaces
⌘K
System
Interpreter
Safety
Traffic light
Joint
Spindle
Camera
Probe
Feed/speed override
Handwheel
Trajectory
Kinematics
Tool
Tool change area
Plasma
Vacuum bed
IO
RLY board
UIO board
User interface
Docs powered by
Archbee

Probe

6min

[PROBING]

storeProbeTouchPoints

Store touch points The touch points are stored in a file when this is checked. This can be used for digitizing.

probeTouchPointFileName

Touch points file path The file name for storing the touch points. The file is opened at the first probe touch and closed when M30 command is encountered, usually at the end of the G-Code program.

probeDetectUnexpectedTrigger

Pause on unexpected probe trigger If enabled the job will be paused if probe is triggered

[SPINDLE_4] (probe)

xOffset

X offset Probe offset in the X axis in relation to the main spindle.

yOffset

Y offset Probe offset in the Y axis in relation to the main spindle.

zOffset

Z offset Probe offset in the Z axis in relation to the main spindle.

onOffOutputPortID

On/off output AUX output to switch the probe on/off if needed.

Did this page help you?
PREVIOUS
Camera
NEXT
Feed/speed override
Docs powered by
Archbee
TABLE OF CONTENTS
[PROBING]
storeProbeTouchPoints
probeTouchPointFileName
probeDetectUnexpectedTrigger
[SPINDLE_4] (probe)
xOffset
yOffset
zOffset
onOffOutputPortID
Docs powered by
Archbee